Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 401 (LIGHTING SYSTEMS)COMPONENT LOCATORLIGHTING SYSTEMS COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Lighting Systems Component Views
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Lighting Systems Component Views
WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Headlamp Switch |
| 2 | Instrument Panel Cluster (IPC) |
| 3 | Dimmer Switch |
| 4 | Sunshade Lamps (Not Used) |
| 5 | Dome Lamps, Front and Rear |
| 6 | Liftgate Lamps, Left and Right |
| 7 | PRNDL Lamp |
| 8 | Cigar Lighter |
| 9 | Radio |
| callout | component name | |
| (1) | Park/Turn Signal Lamp - RF | |
| (2) | Headlamp - Right - High Beam | |
| (3) | Headlamp - Right - Low Beam | |
| (4) | Ambient Light Sensor | |
| (5) | Park/Turn Signal Lamp - LF | |
| (6) | Headlamp - Leftt - High Beam | |
| (7) | Fog Lamp - Left | |
| (8) | Headlamp - Leftt - Low Beam | |
| (9) | Fog Lamp - Right | |
| Callout | Component Name | |
| (1) | Center High Mounted Stop Lamp (CHMSL) | |
| (2) | License Lamp - Left | |
| (3) | License Lamp - Right | |
| (4) | Park/Stop Lamp - RR | |
| (5) | Park/Turn Signal Lamp - RR | |
| (6) | Backup Lamp - Right | |
| (7) | Backup Lamp - Left | |
| (8) | Park/Turn Signal Lamp - LR | |
| (9) | Park/Stop Lamp -LR | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.