Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 399 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Installation Procedure
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
- Install the rearview mirror. Refer to Rearview Mirror Replacement .
- Install the interior windshield pillar garnish molding. Refer to Windshield Upper Garnish Molding Replacement in Interior Trim.
- Install the windshield frame appliques. Refer to Applique Replacement - Windshield Frame and Panel Applique Replacement - Roof Front in Exterior Trim.
- Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Install the windshield wipers arms and blades. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.