Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 398 (COMPUTER/INTEGRATING SYSTEMS)COMPONENT LOCATORCOMPUTER/INTEGRATING SYSTEMS COMPONENT VIEWSCOMPUTER/INTEGRATING SYSTEM COMPONENTS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Computer/Integrating System Components
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Computer/Integrating System Components
WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Powertrain Control Module (PCM) (L66), Engine Control Module (ECM) (L61) |
| 2 | Power Steering Control Module (PSCM) |
| 3 | Body Control Module (BCM), Radio |
| 4 | Door Latch - Front Passenger, Rest Similar |
| 5 | Inflatable Restraint Sensing and Diagnostic Module (SDM) |
| 6 | Liftgate Latch |
| 7 | Data Link Connector (DLC) |
| 8 | Vehicle Communication Interface Module (VCIM) |
| 9 | Instrument Panel Cluster (IPC) |
| 10 | Transmission Control Module (TCM) (L61 w/4T45-E) |
| 11 | Passlock Sensor |
| 12 | Transmission Control Module (TCM) (L61 w/VT25-E) |
| 13 | Electronic Brake Control Module (EBCM) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.