Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Body Control Module (BCM)
- Battery Voltage
-
Display indicates battery voltage. Measured in volts.
- Brake Applied Output Signal
-
Displays ON/OFF status of the brake pedal switch.
- Shift Lock Solenoid Command
-
Displays indicates ACTIVE when the brake switch is depressed on Floor Shift.
- Shift Lock Solenoid Command:
-
Displays indicate INACTIVE when the brake switch is depressed on Column Shift.
- Ignition 1 Signal
-
Display indicates ON when the ignition 1 input circuit of the module receives a battery signal from the ignition switch.
- Remote Start
-
Display indicates the current status of the remote start request.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.