Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 365 (ANTILOCK BRAKE SYSTEM WITH TRACTION CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C0179CIRCUIT/SYSTEM TESTING
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Circuit/System Testing
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Note: Allow brakes to cool down before performing test.
- With scan tool clear the DTC.
- With scan tool connected test drive the vehicle under normal braking conditions and without causing TCS or ABS activation. Verify DTC C0179 resets.
- If the DTC resets replace the EBCM.
- Refer to Diagnostic Aids .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.