Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 347 (THEFT DETERRENT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Scan Tool Data List
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Body Control Module (BCM)
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition in ON, Engine OFF | |||
| Auto Learn Timer Status | Security Data | Seconds | 0-2550 |
| Door Ajar Switches | Inputs | Open/Closed | Closed |
| His. DTC Cyc. Counts | Security Data | Counts | 0-255 |
| Key Cylinder Unlock | Inputs | On/Off | Off |
| Lockout Timer Status | Security Data | Seconds | 0-2550 |
| Passlock Data Voltage | Security Data | Volts | 0-5V |
| Security Lamp State | Security Data | On/Off | Off |
| Seed & Key Timer Status | Security Data | Seconds | 0-2550 |
Powertrain Control Module (PCM)
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON, Engine OFF | |||
| PCM/VCM in VTD Fail Enable | Engine Data 1 | Yes/No | No |
| VTD Auto Learn Timer | Engine Data 1 | Active/Inactive | Inactive |
| VTD Fuel Disable | Engine Data 1 | Active/Inactive | Inactive |
| VTD Fuel Disable Until Ign. OFF | Engine Data 1 | Yes/No | No |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.