Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 337 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSGENERATOR REPLACEMENT (RPO LS4)REMOVAL PROCEDURE

2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Removal Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Removal Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Generator Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (RPOs LZE/LZ4/LZ9) or Battery Negative Cable Disconnect/Connect Procedure (RPO LS4) .
Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
Remove the drive belt. Refer to Drive Belt Replacement - Accessory .
Disconnect the generator electrical connector (2).
Position aside the protective boot (1) from the generator output BAT terminal for access.
Remove the generator output BAT terminal nut (4) and remove the positive battery lead (3) from the generator.

Fig 2: View Of Generator & Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the generator bolts and generator.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.