SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 336 (ENGINE CONTROL SYSTEM - 5.3L - INTRODUCTION (2 OF 2))COMPONENT LOCATORENGINE CONTROLS COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Engine Controls Component Views

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Engine Controls Component Views
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: LF Of The Engine Compartment
GM1653137Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Mass Air Flow (MAF) / Intake Air Temperature (IAT) Sensor
2 Brake Fluid Level Switch
3 Windshield Wiper Motor
4 Electronic Brake Control Module (EBCM)
5 A/C Refrigerant Pressure Sensor
6 Transmission Control Module (TCM)
7 Engine Control Module (ECM)
8 G101
9 Inflatable Restraint Front end Sensor - Left
Fig 2: Left Top Side Of Engine
GM1677719Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Throttle Body
2 Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
3 Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Connector
Fig 3: Front Of Engine
GM1574059Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Engine Coolant Temperature (ECT) Sensor
2 Ignition Coil 1
3 Ignition Coil 3
4 Ignition Coil 5
5 Ignition Coil 7
6 Manifold Absolute Pressure (MAP) Sensor
7 Throttle Body
8 Engine Coolant Heater
9 Knock Sensor (KS) Bank 1
10 Engine Oil Level Switch
11 Camshaft Position (CMP) Sensor
Fig 4: Top Of Engine
GM1574068Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Ignition Coil 8
2 Fuel Injector 8
3 Evaporative Emission (EVAP) Canister Purge Solenoid Valve
4 Manifold Absolute Pressure (MAP) Sensor
5 Throttle Body
6 Engine Oil Pressure (EOP) Sensor
7 Fuel Injector 7
8 Ignition Coil 7
9 Fuel Injector 5
10 Ignition Coil 5
11 Fuel Injector 3
12 Ignition Coil 3
13 Fuel Injector 1
14 Ignition Coil 1
15 Fuel Injector 2
16 Ignition Coil 2
17 Fuel Injector 4
18 Ignition Coil 4
19 Fuel Injector 6
20 Ignition Coil 6
Fig 5: Rear Of Engine
GM1574070Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Ignition Coil 7
2 Throttle Body
3 Ignition Coil 8
4 Ignition Coil 6
5 Ignition Coil 4
6 Ignition Coil 2
7 Heated Oxygen Sensor (HO2S) 1
8 Knock Sensor (KS) Bank 2
9 Crankshaft Position (CKP) Sensor
10 Engine Oil Level Switch
11 Valve Lifter Oil Manifold (VLOM) Assembly
Fig 6: Underbody
GM1203644Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Heated Oxygen Sensor (HO2S) 2
Fig 7: Pedal Assemblies
GM1700245Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Park Brake Switch
2 Dash Panel
3 Brake Pedal Position Sensor
4 Accelerator Pedal Position (APP) Sensor
Fig 8: Fuel Tank Components
GM1653116Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Fuel Tank
2 Fuel Pump and Sender Assembly
3 Fuel Pump
4 Evaporative Emission (EVAP) Canister Vent Solenoid Valve
Fig 9: Fuel Pump And Sender Assembly
GM886471Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Fuel Line Quick Connector
2 Fuel Pump
3 Base Plate
4 Fuel Strainer
5 Fuel Level Sensor
6 Springs
7 Fuel Tank Pressure (FTP) Sensor
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.