Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 330 (ENTERTAINMENT SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESRADIO POOR RECEPTIONRADIO ANTENNA MODULE SYSTEM
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Radio Antenna Module System
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Radio Antenna Module System
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The following information lists the most probable cause of the concern to the least probable cause followed by the appropriate test for that condition. If the test leads to the replacement of a component, always inspect for a poor connection before proceeding with the replacement. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems.
This antenna system consists of an antenna module and a grid separate from the heated grid element.
Perform the Antenna System Test and test the antenna coax cable prior to performing the following tests:
- The radio antenna module is not grounded properly. The module grounding screws should be clean and tight. Measure the resistance from the antenna module base plate to a good ground. Resistance should be 0.020 ohms or less. Find and correct the condition if the resistance is out of specification.
- The antenna module supply voltage circuit to the radio antenna module is open or shorted to ground. Test the antenna module supply voltage circuit for an open or short to ground. Refer to Circuit Testing andWiring Repairs in Wiring Systems.
- No antenna module supply voltage output from the radio. Disconnect the radio antenna module connector. Turn ON the radio and measure the voltage from the antenna module supply voltage circuit of the radio to a good ground. Voltage measured should be near 12 volts. If no voltage is measured, replace the radio. Refer to Radio Replacement for service procedure. Perform the VIN Relearn procedure after replacing the radio. On the scan tool, go to Module Replacement/Setup in Vehicle Control Systems and select Radio.
- Defective radio antenna module. Replace the radio antenna module.
- After finding and correcting the condition, operate the system in order to verify the repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.