Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 330 (ENTERTAINMENT SYSTEMS)COMPONENT LOCATORENTERTAINMENT COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Entertainment Component Views
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Entertainment Component Views
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Radio Amplifier (U88) |
| 2 | Speaker - LR |
| 3 | Speaker - LF Door |
| 4 | Speaker - LF Tweeter |
| 5 | Speaker - Center (U88) |
| 6 | Radio |
| 7 | Speaker - RF Tweeter |
| 8 | Speaker - RF Door |
| 9 | Speaker - RR |
| Callout | Component Name |
|---|---|
| 1 | Headlamp Switch |
| 2 | Instrument Panel Cluster (IPC) |
| 3 | Driver Information Center (DIC) Switch |
| 4 | Ambient Light Sensor |
| 5 | Inflatable Restraint Passenger Air Bag On/Off Indicator (Sedan w/o 9C1, 9C3) |
| 6 | Radio |
| 7 | I/P Trim Panel |
| 8 | Heated Seat Switch-Passenger (KA7) |
| 9 | HVAC Control Module |
| 10 | Heated Seat Switch-Driver (KA7) |
| 11 | Turn Signal / Multifunction Switch |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.