Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 324 (COMPUTER/INTEGRATING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Scan Tool Data List
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: ignition ON, engine OFF. | |||
| Battery Voltage Signal | Data | Volts | Varies |
| Accy/RAP Relay Command | Outputs | On/Off | On |
| Accessory Relay Command | Outputs | On/Off | On |
| Current Power Mode | Inputs | Off/Accessory/Run/Crank Request | Varies |
| Ign. Off/Run/Crank | Inputs | Key Out/ACC Crank Run Key In/Off |
Varies |
| Ignition Accessory/Run | Inputs | Active/Inactive | Active |
| Ignition Run/Crank | Inputs | Active/Inactive | Active |
| Key in Ignition Status | Inputs | Key Out/Key In | Key In |
| Off/Run/Crank Reference | Data | Volts | Varies |
| Off/Run/Crank Signal | Data | Volts | Varies |
| Run/Crank Relay Command | Outputs | On/Off | Off |
| Run Relay Command | Outputs | On/Off | On |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.