SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 321 (CELLULAR COMMUNICATION SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESVOICE RECOGNITION INOPERATIVE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Voice Recognition Inoperative

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Voice Recognition Inoperative
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Voice Recognition Inoperative

Step Action Yes No
Schematic Reference: OnStar Schematics 
Connector End View Reference: Cellular Communication Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
IMPORTANT: The vehicle must be located in a quiet area.
  1. Turn ON the ignition, with the engine OFF.
  2. Press the OnStar® Call Center button.
  3. Ask the OnStar® operator if your voice can clearly be heard.
Does the OnStar® operator hear your voice?		 Go to Step 3  Go to Microphone Inoperative - Caller Cannot Be Heard 
3
  1. Press the Call Answer button.
  2. Pronounce all hands-free commands. Refer to OnStar Description and Operation  for proper pronunciation.
Did the OnStar® system recognize any of the voice commands?		 Go to Step 5  Go to Step 4 
4
  1. Press the Call Answer button.
  2. Have another person pronounce all hands-free commands. Refer to OnStar Description and Operation  for proper pronunciation.
Did the OnStar® system recognize any of the voice commands?		 Go to Step 5  Go to OnStar Description and Operation 
5 The system is operational, but cannot identify certain word commands due to pronunciation. For tips on proper pronunciation refer to OnStar Description and Operation .
Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.