Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 282 (HYDRAULIC BRAKE SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Fastener Tightening Specifications
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Brake Hose to Brake Caliper Bolt | 54 N.m | 40 lb ft |
| Brake Pedal Bolt and Nut | 40 N.m | 30 lb ft |
| Brake Pipe Fittings (Tube Nut) at the Wheels | 18 N.m | 13 lb ft |
| Brake Pipes at Master Cylinder with ABS | 30 N.m | 22 lb ft |
| Brake Pipes at Master Cylinder without ABS, Front | 27 N.m | 20 lb ft |
| Brake Pipes at Master Cylinder without ABS, Rear | 25 N.m | 18 lb ft |
| EGR Valve Wiring Harness Heat Shield Nut and Bolt | 10 N.m | 89 lb in |
| Master Cylinder Mounting Nuts | 33 N.m | 24 lb ft |
| Rear Brake Pipe Union to Brake Pipe Bundle | 17 N.m | 13 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.