Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 270 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWIPERS/WASHER SWITCH REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Windshield Wiper & Washer Switch

Courtesy of GENERAL MOTORS CORP.

Install the windshield wiper and washer switch (1) to the steering column.

Fig 2: View of Windshield Wiper & Washer Switch Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors (1,3) on the windshield wiper and washer switch.

Fig 3: View of Wire Harness & Shield

Courtesy of GENERAL MOTORS CORP.

Install the wire harness (2) to the wire harness shield (1) on the lower steering column.

Fig 4: Identifying Steering Column Wiring Harness Straps

Courtesy of GENERAL MOTORS CORP.

Route and connect the electrical connector from the windshield wiper and washer switch.
Install the wiring harness tie straps (1,2).
Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement (Manual Tilt) in Steering Wheel and Column.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.