SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 270 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER MOTOR, WIPER SYSTEM MODULE REPLACEMENT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Wiper Motor, Wiper System Module Replacement

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Wiper Motor, Wiper System Module Replacement
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Wiper Motor & Wiper System Module
GM1536843Courtesy of GENERAL MOTORS CORP.
Wiper Motor & Wiper System Module Replacement

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the wiper arms. Refer to Wiper Arm, Blade, Insert Replacement - Front .
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
1 Wiper System Module Bolt (Qty: 3)

Tighten:  10 N.m (89 lb in)
2 Wiper System Module Nut (Qty: 1)

Tighten:  10 N.m (89 lb in)
3 Wiper Motor Nut (Qty: 3)

Tighten:  10 N.m (89 lb in)
4 Wiper Drive System Module
5 Wiper Motor
Tip:  Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.