Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 265 (OBJECT DETECTION SYSTEM)COMPONENT LOCATOROBJECT DETECTION COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Object Detection Component Views
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Object Detection Component Views
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Reading Lamps - Overhead Console |
| 2 | Garage Door Opener |
| 3 | Dome/Reading Lamp - Left |
| 4 | Rear Park Assist (RPA) Display |
| 5 | Dome/Reading Lamp - Right |
| Callout | Component Name |
|---|---|
| 1 | Audio Amplifier |
| 2 | Remote Control Door Lock Receiver (RCDLR) |
| 3 | Navigation Antenna |
| 4 | Rear Window Shelf |
| 5 | Rear Parking Assist (RPA) Module |
| 6 | Electronic Compass Module |
| 7 | Rear Compartment Courtesy Lamp |
| Callout | Component Name |
|---|---|
| 1 | Rear Parking Assist (RPA) Diagnostic Connector |
| Callout | Component Name |
|---|---|
| 1 | Rear Window Defogger Grid |
| 2 | Center High Mounted Stop Lamp (CHMSL) |
| 3 | Backup Lamp - Right |
| 4 | Tail Lamp - Right Upper |
| 5 | Tail/Stop and Turn Signal Lamp - Right |
| 6 | Marker Lamp - Right |
| 7 | Tail Lamp - Right Lower |
| 8 | Object Sensor - RR Corner |
| 9 | Object Sensor - RR Middle |
| 10 | License Lamp - Right |
| 11 | License Lamp - Left |
| 12 | Object Sensor - LR Middle |
| 13 | Object Sensor - LR Corner |
| 14 | Tail Lamp - Left Lower |
| 15 | Marker Lamp - Left |
| 16 | Tail/Stop and Turn Signal Lamp - Left |
| 17 | Backup Lamp - Left |
| 18 | Tail Lamp - Left Upper |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.