Keyless Entry Antenna Replacement

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Keyless Entry Antenna Replacement
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Keyless Entry Antenna
GM1618159Courtesy of GENERAL MOTORS CORP.
Keyless Entry Antenna Replacement

Callout Component Name
Fastener Tightening Specifications:Β  Refer to Fastener Tightening Specifications .

Preliminary Procedure

  1. Remove the rear seat cushion. Refer to Seat Cushion Replacement - Rear .
  2. Remove the rear seat back. Refer to Seat Back Replacement - Rear (Non-folding) or Seat Back Replacement - Rear (Folding) .
  3. Remove the rear quarter upper trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper .
  4. Remove the rear window shelf trim panel. Refer to Trim Panel Replacement - Rear Window Shelf .
1 Remote Control Door Lock Receiver Antenna Assembly
Tip:Β  Disconnect the antenna from the door lock receiver.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.