SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 248 (INSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLE)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Fastener Tightening Specifications

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications

Application Specification
Metric English
Body Control Module (BCM) Bracket Bolts 2 N.m 18 lb in
Front Floor Console Cupholder Screw 2 N.m 18 lb in
Front Floor Console Front Compartment Screw 2 N.m 18 lb in
Front Floor Console Horizontal Bolt 10 N.m 89 lb in
Front Floor Console Trim Plate Screw 2 N.m 18 lb in
Front Floor Console Trim Ring Screw 2 N.m 18 lb in
Inside Air Temperature Sensor 2 N.m 18 lb in
Instrument Panel Cluster Screw 2 N.m 18 lb in
Instrument Panel Cluster Trim Plate Screw 2 N.m 18 lb in
Instrument Panel Compartment Latch Screw 2 N.m 18 lb in
Instrument Panel Compartment Striker Screw 2 N.m 18 lb in
Instrument Panel Trim Pad at Cluster Pocket Bolt 10 N.m 89 lb in
Instrument Panel Trim Pad Center and Lower Bolt 10 N.m 89 lb in
Instrument Panel Trim Pad Upper or Windshield, Bolt 10 N.m 89 lb in
Knee Bolster Bracket at Instrument Panel Bolt 10 N.m 89 lb in
Knee Bolster Bracket at Steering Column Support Bolt 22 N.m 16 lb ft
Rear Floor Console Door Hinge Screw 2 N.m 18 lb in
Steering Column Opening Filler Panel Bolt 2 N.m 18 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.