SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 246 (ENTERTAINMENT SYSTEMS)REPAIR INSTRUCTIONSSPEAKER REPLACEMENT - FRONTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Center Speaker & Electrical Connector
    GM929169Courtesy of GENERAL MOTORS CORP.
  1. Connect the front speaker electrical connector to the front speaker.
    2. Fig 2: View Of Center Speaker
    GM929237Courtesy of GENERAL MOTORS CORP.
  2. Lower the speaker into the opening in the I/P.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the center speaker screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    4. Fig 3: Removing/Installing Front Speaker
    GM1282682Courtesy of GENERAL MOTORS CORP.
  4. Align the speaker grille to the I/P.
  5. Press the speaker grille into the I/P.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.