SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 243 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHIGH MOUNTED STOP LAMP REPLACEMENT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

High Mounted Stop Lamp Replacement

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION High Mounted Stop Lamp Replacement
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Trim Panel - Rear Window Shelf
GM1541778Courtesy of GENERAL MOTORS CORP.
High Mounted Stop Lamp Replacement

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the rear seat cushion. Refer to Seat Cushion Replacement - Rear .
  2. Remove the rear seat back. Refer to Seat Back Replacement - Rear (Non-folding) or Seat Back Replacement - Rear (Folding) .
  3. Remove the rear upper quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper .
1 Rear Window Panel Trim Retainer (Qty: 2)
Tip:  Use a J 38778  Door Trim Clip Remover or equivalent to remove the retainer.
2 Rear Window Panel Trim Assembly
Tip: 
  1. Lift the panel and remove the outside seat belts through the slots in the trim panel.
  2. Lift the panel and remove the center seat belt escutcheon, then pass it and the center seat belt through the slot in the trim panel.
  3. Slide the panel forward to disengage the integral hook from the retaining hole.
  4. Disconnect the electrical connector from the high mount stop lamp.
3 High Mount Stop Lamp Nut (Qty: 2)

Tighten:  2 N.m (18 lb in)
4 High Mount Stop Lamp
Tip:  The high mount stop lamp uses LED bulbs and must be serviced as an assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.