Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (DOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Fastener Tightening Specifications
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Check Link to Body Bolt | 10 N.m | 89 lb in |
| Door and Reinforcement Plate to Hinge Nuts | 30 N.m | 22 lb ft |
| Door Check Link to Body Bolt | 10 N.m | 89 lb in |
| Door Check Link to Hinge Pillar Bolt | 10 N.m | 89 lb in |
| Door Hinge to Hinge Pillar Bolts | 30 N.m | 22 lb ft |
| Door Striker to Body Bolts | 20 N.m | 15 lb ft |
| Door Trim Panel Fasteners | 1.5 N.m | 13 lb in |
| Door Trim Panel Lower Fasteners | 1.5 N.m | 13 lb in |
| Front Window Regulator Bolts | 10 N.m | 89 lb in |
| Hinge Fasteners | 30 N.m | 22 lb ft |
| Latch to Door Bolts | 10 N.m | 89 lb in |
| Mirror Attachment Nuts | 10 N.m | 89 lb in |
| Mirror Motor to Mirror Housing Screws | 3 N.m | 27 lb in |
| Outer Belt Seal Fasteners | 2 N.m | 18 lb in |
| Outer Door Panel Fasteners (Use Threadlocker) | 6 N.m | 53 lb in |
| Rear Window Regulator Bolts | 10 N.m | 89 lb in |
| Weatherstrip Guide Bolts | 10 N.m | 89 lb in |
| Window Guide Bolt | 10 N.m | 89 lb in |
| Window Run Channel Fastener | 10 N.m | 89 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.