SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (INTERIOR TRIM)REPAIR INSTRUCTIONSCARPET REPLACEMENT - FRONTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Driver Side Carpet Retaining Fastener
    GM896597Courtesy of GENERAL MOTORS CORP.
  1. Cut the replacement carpet in the same location as the removed carpet.
  2. Install the front carpet in the vehicle tucking the carpet under the HVAC module and under the shift rod. Make sure that the carpet is properly placed to prevent wrinkles.
  3. Install the driver side carpet retaining fastener.
    4. Fig 2: Removing & Installing Carpet Retainers
    GM896658Courtesy of GENERAL MOTORS CORP.
  4. Install the right and the left carpet retainers. Refer to Carpet Retainer Replacement .
    5. Fig 3: Removing & Installing Hinge Pillar Trim
    GM896480Courtesy of GENERAL MOTORS CORP.
  5. Install the hinge pillar. Refer to Trim Replacement - Hinge Pillar .
    6. Fig 4: Removing & Installing Console
    GM896495Courtesy of GENERAL MOTORS CORP.
  6. Install the center console. Refer to Console Replacement .
    7. Fig 5: Removing/Installing Front Seat
    GM896861Courtesy of GENERAL MOTORS CORP.
  7. Install the seats. Refer to Seat Replacement - Front Bucket .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.