SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 163 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSSIR DISABLING AND ENABLING ZONE 2ENABLING PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Enabling Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Enabling Procedure
WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition switch.
  2. To enable the roof rail module - left, perform steps 3-8. To enable both the roof rail module - left and the seat belt pretensioner - LF, continue to step 3.
  3. Connect the roof rail module - left connector to the vehicle harness connector.
  4. Install the CPA to the roof rail module - left connector.
    Fig 1: Locating CPA & Roof Rail Module Connector
    GM1244657Courtesy of GENERAL MOTORS CORP.
  5. Install the rear coat hooks. Refer to Coat Hook Replacement in Interior Trim.
  6. Install the rear headliner push-in retainers.
  7. Install both the left and right rear corner garnish moldings. Refer to Garnish Molding Replacement - Rear Corner in Interior Trim.
  8. Install the upper rear window molding. Refer to Molding Replacement - Rear Window Upper in Interior Trim.
  9. Connect the seat belt pretensioner - LF connector and install the CPA.
    Fig 2: View Of Seat Belt Pretensioner Connector And Wiring Harness Routing
    GM899818Courtesy of GENERAL MOTORS CORP.
  10. Install the lower center pillar trim. Refer to Garnish Molding Replacement - Center Pillar Lower in Interior Trim.
  11. Install the AIR BAG fuse into the body control module fuse center.
  12. Install the body control module fuse center cover.
  13. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  14. Perform the Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.