Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the carpet in the vehicle.
    Fig 1: View Of Floor Carpet
    GM930880Courtesy of GENERAL MOTORS CORP.
  2. Tuck the carpet under the center pillar assemblies.
  3. Install the center console trim panels and the center console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  4. Install the rear carpet retainer. Refer to Carpet Retainer Replacement - RearΒ .
  5. Install the front carpet retainer. Refer to Carpet Retainer Replacement - FrontΒ .
  6. Install the rear seats. Refer to Seat Replacement - Rear in Seats.
  7. Install the front seats. Refer to Seat Replacement - Front Bucket in Seats.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.