SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 157 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSFIXED ANTENNA REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Removal Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front fender. Refer to Fender Replacement - Front in Body Front End.
  2. Pull to remove the antenna mast bezel.
    Fig 1: View Of Antenna Mast Bezel
    GM936189Courtesy of GENERAL MOTORS CORP.
  3. Remove the antenna mast from the antenna base by turning counterclockwise.
  4. Disconnect the antenna lead-in from the antenna base.
    Fig 2: View Of Antenna Lead-In To Antenna Base
    GM933124Courtesy of GENERAL MOTORS CORP.
  5. Remove the antenna base fasteners from the bracket on the antenna base.
  6. Remove the antenna base.
    Fig 3: View Of Antenna Base & Fasteners
    GM933069Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.