Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 155 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSREADING LAMP REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Pull the headliner down slightly and slide the forward reading lamp into place.

Fig 1: Pulling Headliner Down Slightly & Slide Forward Reading Lamp
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connector to the reading lamp.

Fig 2: Disconnecting/Connecting Electrical Connector To The Reading Lamp
Courtesy of GENERAL MOTORS CORP.
If the vehicle is equipped with OnStar®, install the microphone. Refer to OnStar Microphone Replacement in Cellular Communication.
Position the forward reading lamp cover into the rear attaching hooks.
If the vehicle is equipped with a sunroof or with OnStar®, connect the electrical connectors.

Fig 3: Disconnecting/Connecting Electrical Connectors At Reading Lamp Cover/Sunroof Switch
Courtesy of GENERAL MOTORS CORP.
Rotate the front reading lamp cover forward into the lamp assembly. Snap the cover into place.
If the vehicle is equipped with a sunroof, install the sunroof switch knob.

NOTE: Refer to Fastener Notice in Cautions and Notices.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.