Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 155 (LIGHTING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Scan Tool Data List
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Exterior Lamps
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Ignition On, Engine Off | ||
| Battery 1 | Volts | Battery Voltage |
| DRL Relay Command | On/Off | On when requested |
| DRL Relay Feedback | High/Low | Low when requested |
| Fog Lamp Relay Cmd. | On/Off | On when requested |
| Fog Lamp Relay Fdbk. | High/Low | Low when requested |
| Fog Lamps Switch | On/Off | On when requested |
| High Beam Switch | On/Off | On when requested |
| Low Beam Input | Volts | 0.4 volts - Battery Voltage |
| Low Beam Input = Off | Yes/No | No when Low Beams requested |
| Low Beam Input = DRL | Yes/No | Yes when DRL requested |
| Low Beam Input = High | Yes/No | No when Low Beams requested |
| Park Lamp Switch | On/Off | On when Park Lamps requested |
Interior Lamps
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Ignition On, Engine Off | ||
| Dome Lamp Command | On/Off | On when Dome requested |
| Dome Lamp Feedback | High/Low | Low when Dome requested |
| Driver Door Switch | High/Low | Low with Driver Door Open |
| Inadvertent Power Cmd. | On/Off | On |
| Inadvertent Power Fdbk. | High/Low | Low |
| I/P Dimmer Input | Volts | 0.5-4 volts |
| I/P Dimmer Output | % | 20-100% |
| Key In Ignition | Yes/No | Yes |
| Pass Door Switches | High/Low | Low with any Door Open |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.