Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 143 (HEATING, VENTILATION AND AIR CONDITIONING)REPAIR INSTRUCTIONSBLOWER CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Installation Procedure
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Install the blower control module.
- Install the 2 new screws in the pre-drilled holes to the side of the heat stakes in the blower control module and the HVAC module assembly.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
- Connect the electrical connector to the blower control module.
- Install the right side I/P insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages, and Console.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.