Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSSPEAKER REPLACEMENT - FRONT LOWERINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Installation Procedure
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the wire harness to the speaker.
- Position the speaker in the door assembly, with the word TOP at the top of the speaker.
- Install the fasteners.
Tighten: Tighten the fasteners to 1.5 N.m (13 lb in).
- Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door in Doors.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.