SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 125 (ENGINE EXHAUST SYSTEM)REPAIR INSTRUCTIONSEXHAUST HANGER REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Exhaust Pipe Rear Hangers
    GM194710Courtesy of GENERAL MOTORS CORP.
  1. Install the exhaust pipe rear hangers to the muffler and the rear exhaust hanger brackets.
    2. Fig 2: View Of Exhaust Pipe Hanger
    GM373046Courtesy of GENERAL MOTORS CORP.
  2. Install the exhaust pipe hanger to the exhaust pipe and the exhaust hanger bracket.
    3. Fig 3: Locating Exhaust Pipe Components
    GM892635Courtesy of GENERAL MOTORS CORP.
  3. Install the exhaust pipe hanger (3) to the exhaust pipe (2) and the exhaust hanger bracket (1).
  4. Remove the support from the exhaust system.
  5. Inspect the exhaust system for underbody contact.
  6. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.