Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (ENGINE CONTROLS - INTRODUCTION)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Fastener Tightening Specifications
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specifications | |
|---|---|---|
| Metric | English | |
| Accelerator Pedal Position Assembly-to-Brake Bracket Bolt | 25 N.m | 18 lb ft |
| Battery Terminal Bolts | 17 N.m | 13 lb ft |
| Belt Tensioner Bolts | 40 N.m | 30 lb ft |
| Camshaft Position Sensor | 8 N.m | 71 lb in |
| Crankshaft Position Sensor Bolt | 8 N.m | 71 lb in |
| Engine Control Module Attachment Bolts | 8 N.m | 71 lb in |
| Engine Coolant Temperature Sensor | 18 N.m | 13 lb ft |
| Engine Oil Pressure Switch | 10 N.m | 89 lb in |
| Generator Mounting Bolts | 40 N.m | 30 lb ft |
| Ignition Module Bolts | 8 N.m | 71 lb in |
| Intake Plenum Switchover Valve Bolts | 8 N.m | 71 lb in |
| Knock Sensor Bolt | 20 N.m | 15 lb ft |
| Manifold Absolute Pressure Sensor Bolt | 5 N.m | 44 lb in |
| Oxygen Sensors (Exhaust Manifold) | 50 N.m | 37 lb ft |
| Oxygen Sensors (Lower Exhaust Pipe) | 45 N.m | 33 lb ft |
| Power Steering Pump Pulley Bolt | 20 N.m | 15 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.