SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (ENGINE CONTROLS - INTRODUCTION)COMPONENT LOCATORENGINE CONTROLS COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Engine Controls Component Views

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Engine Controls Component Views
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying 3.0L Engine Front Components
GM1253903Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Camshaft Position (CMP) Sensor
2 Mass Air Flow (MAF) Sensor
3 Throttle Actuator Control (TAC) Module
4 Ignition Control Module (ICM)
5 Engine Control Module (ECM)
6 Engine Coolant Temperature (ECT) Sensor
7 Crankshaft Position (CKP) Sensor
8 Knock Sensor (KS) 2
9 A/C Compressor Clutch Coil (Hidden)
10 Heated Oxygen Sensor (HO2S) Bank 2 Sensor 1
11 Generator
Fig 2: Identifying Right Side Of The Engine Compartment
GM1465084Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Mass Air Flow (MAF) Sensor
Fig 3: Identifying LR Of The Engine Components (3.0L)
GM1335096Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 C150
2 Intake Manifold Runner Control (IMRC) Solenoid
Fig 4: Identifying Front Of The Transmission
GM1465086Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 C100 (3.0L)
2 G113
3 G110 (3.0L)
Fig 5: 3.0L Engine Rear Components
GM1350558Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Throttle Actuator Control (TAC) Module
2 Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1
3 Knock Sensor (KS) 1
4 Engine Oil Pressure (EOP) Switch
5 Starter
6 Intake Manifold Runner Control (IMRC) Solenoid
Fig 6: Identifying Accelerator Pedal Components
GM1464543Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Accelerator Pedal Position (APP) Sensor
2 C225
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.