SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - 2.4L - INTRODUCTION (2 OF 2)REPAIR INSTRUCTIONSFILLER TUBE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
  1. Remove the caps or plugs from the fuel tank opening and vent line.
  2. Install the fuel fill hose to the fuel tank. Align the "D" notch on the fill hose (1) with the "D" notch on the fuel tank (1).
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the fuel fill hose clamp (3) at the fuel tank.

    Tighten:  Tighten the clamp to 4.5 N.m (40 lb in).

    4. Fig 1: Connecting Fuel Tank Vent Line Quick Connect Fitting To Fill Pipe Recirculation Line
    GM1656960Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel tank vent line quick connect fitting (2) to the fill pipe recirculation line. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    5. Fig 2: Installing Fuel Fill Pipe Lower Bolt
    GM1656988Courtesy of GENERAL MOTORS CORP.
  5. Install the fuel fill pipe lower bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  6. Remove the cap or plug from the EVAP canister fitting.
    7. Fig 3: Connecting Fuel Tank Evaporative Emission Line Quick Connect Fittings
    GM1656958Courtesy of GENERAL MOTORS CORP.
  7. Connect the fuel fill vent pipe quick connect fitting (1) to the EVAP canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  8. Lower the vehicle.
  9. Install the fuel fill pocket. Refer to Fuel Filler Pocket Replacement .
  10. Refill the fuel tank.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.