Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - 2.4L - INTRODUCTION (2 OF 2)REPAIR INSTRUCTIONSAIR CLEANER ELEMENT REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure

Fig 1: Identifying Air Cleaner Assembly

Courtesy of GENERAL MOTORS CORP.

Install the air cleaner filter into the lower air cleaner housing.
Install the upper air cleaner cover to the lower air cleaner housing.
Engage the air cleaner latches.

Fig 2: View Of MAF/IAT Sensor Engine Harness Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
Connect the engine harness electrical connector to the MAF/IAT sensor.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.