Console Replacement - Front Floor

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Console Replacement - Front Floor
Fig 1: Console Replacement - Front Floor
GM1546436Courtesy of GENERAL MOTORS CORP.
Console Replacement - Front Floor

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the armrest if equipped. Refer to Console Armrest Replacement - Front Floor .
  2. Remove the console rear trim plate. Refer to Trim Plate Replacement - Console Rear .
  3. Remove the console front trim plate. Refer to Trim Plate Replacement - Console Front .
  4. Remove the rear cup holder. Refer to Cup Holder Replacement - Front Floor Console - Rear .
  5. Remove the console extensions. Refer to Extension Replacement - Floor Console - Side .
1 Screw, Console Mounting

Tighten:  2 N.m (18 lb in)

2 Console Assembly, Center Floor
Tip:  Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.