Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORSOLENOIDS & SOLENOID VALVES
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Solenoids & Solenoid Valves
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Solenoids & Solenoid Valves
SOLENOIDS & SOLENOID VALVES LOCATION
| Component | Location |
|---|---|
| A/C Compressor Clutch (2.0L) | In lower right side of engine, below generator. See Figure. |
| A/C Compressor Clutch (2.2L) | Left front of engine. See Figure. |
| A/T Shift Lock Control Solenoid | At gear selector. See Figure. |
| Evaporative Emission (EVAP) Canister Purge Solenoid Valve (2.4L) | Top rear of engine. See Figure. |
| Evaporative Emission (EVAP) Canister Purge Solenoid (2.0L) | On top of engine near oil fill cap. See Figure. |
| Evaporative Emission (EVAP) Canister Purge Solenoid (2.2L) | On top of engine. See Figure. |
| Evaporative Emissions (EVAP) Canister Vent Solenoid Valve | Under rear of vehicle, behind fuel tank attached to EVAP canister. See Figure. |
| Fuel Injector 1 (2.0L) | On top front of engine, under fuel rail assembly. |
| Fuel Injector 1 (2.2L) | On top front of engine, under fuel rail assembly. |
| Fuel Injector 1 (2.4L) | On top front of engine, under fuel rail assembly. See Figure. |
| Fuel Injector 2 (2.0L) | On top front of engine, under fuel rail assembly. |
| Fuel Injector 2 (2.2L) | On top front of engine, under fuel rail assembly. |
| Fuel Injector 2 (2.4L) | On top front of engine, under fuel rail assembly. See Figure. |
| Fuel Injector 3 (2.0L) | On top front of engine, under fuel rail assembly. |
| Fuel Injector 3 (2.2L) | On top front of engine, under fuel rail assembly. |
| Fuel Injector 3 (2.4L) | On top front of engine, under fuel rail assembly. See Figure. |
| Fuel Injector 4 (2.0L) | On top front of engine, under fuel rail assembly. |
| Fuel Injector 4 (2.2L) | On top front of engine, under fuel rail assembly. |
| Fuel Injector 4 (2.4L) | On top front of engine, under fuel rail assembly. See Figure. |
| Ignition Lock Cylinder Control Solenoid | In steering column, part of ignition lock cylinder. |
| Pressure Control (PC) Solenoid Valve | Inside automatic transmission. See Figure. |
| Starter Solenoid (2.0L) | Left front of engine. See Figure. |
| Starter Solenoid (2.2L) | Left rear of engine compartment. See Figure. |
| Starter Solenoid (2.4L) | Lower left rear of engine block. See Figure. |
| Supercharger Boost Solenoid | On top of engine, near canister purge solenoid. |
| TCC Control PWM Solenoid | In automatic transmission. See Figure. |
| 1-2 Shift Solenoid (1-2 SS) Valve | Inside transmission. See Figure. |
| 2-3 Shift Solenoid (2-3 SS) Valve | Inside transmission. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.