Hazard Warning Switch Replacement

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Hazard Warning Switch Replacement
Fig 1: Hazard Warning Switch Replacement
GM1545589Courtesy of GENERAL MOTORS CORP.
Hazard Warning Switch Replacement

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:Β  Refer to Fastener Tightening SpecificationsΒ .
1 Filler, Instrument Panel Steering Column Opening
Refer to Steering Column Filler Replacement .
2 Plate, Instrument Panel Trim
3 Plate, Instrument Panel Trim
4 Retainer, Instrument Panel Cluster Trim Plate
5 Bolt, Instrument Panel Cluster Trim Plate

Tighten:Β  10 N.m (89 lb in)

6 Screw, Instrument Panel Cluster Trim Plate

Tighten:Β  2.2 N.m (19 lb in)

7 Plate, Instrument Panel Cluster Trim
8 Switch, Hazard Warning
Tip:Β  Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.