Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G3500, VAN CARGO, 4.8 VREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM - 4.3L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSACCELERATOR CONTROLS PEDAL REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Chevy Express G3500, Van Cargo, 4.8 V
Removal Procedure
2006 Chevrolet Chevy Express G3500, Van Cargo, 4.8 VSECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Lift upward on the accelerator pedal (3) to relieve the tension on the cable (2).
- Remove the retainer (1) from the pedal lever (4) hole.
- Remove the cable from the slot in the pedal lever.
- Remove the accelerator pedal mounting fasteners.
- Remove the accelerator pedal assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.