Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G3500, VAN CARGO, 4.8 VREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM - 4.3L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSACCELERATOR CONTROLS CABLE REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Chevy Express G3500, Van Cargo, 4.8 V

Installation Procedure

2006 Chevrolet Chevy Express G3500, Van Cargo, 4.8 VSECTION Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Accelerator Cable At Bulkhead

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable to the bulkhead (1).

Fig 2: View Of Accelerator Cable At Accelerator Pedal

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable to the accelerator pedal (2).

Fig 3: Expanded View Of Accelerator Cable From The Engine Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable to the engine cable bracket.

Fig 4: Identifying Accelerator Cable/Throttle Body Lever

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable to the throttle lever.
Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.