Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMREPAIR INSTRUCTIONSSIR DISABLING AND ENABLING ZONE 9ENABLING PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Enabling Procedure
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Enabling Procedure
- Remove the key from the ignition.
- Connect the RF seat belt pretensioner yellow 2-way connector (1) located under the passenger seat.
- Install the CPA to the RF seat belt pretensioner yellow 2-way connector (1) located under the passenger seat.
- Install the SIR fuse to the fuse block.
- Staying well away from all air bags, turn ON the ignition, with the engine OFF.
- The AIR BAG indicator will flash 7 times.
- The AIR BAG indicator will then turn OFF.
- Perform the Diagnostic System Check - Vehicle , if the AIR BAG indicator does not operate as described.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.