Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMREPAIR INSTRUCTIONSINFLATABLE RESTRAINT FRONT END SENSOR REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Installation Procedure
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
- Remove any dirt, grease, or other impurities from the mounting surface.
- Point the arrow on the sensor toward the front of the vehicle.
- Install the inflatable restraint front end sensor (1) into the keyhole slot in lower radiator support (2).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.