Circuit Description

The inflatable restraint passenger presence system (PPS) is used to monitor the pressure profile of any occupant that is sitting in the front outboard passenger seat and communicate the profile classification to the sensing and diagnostic module (SDM). The SDM will either enable or suppress the deployment of the instrument panel (I/P) module based on the profile classification of the occupant. If the PPS has been replaced the new PPS must run a preload test on the completed serviced seat before that vehicle is released back to the customer. This test assures that completed serviced seat does not add any pressure to the seat surface that could influence the pressure profile of any occupant that is sitting in the seat. This test must be performed on an empty seat. When a new PPS is installed a DTC will set indicating that a preload test needs to be preformed. If the PPS detects any preload DTC within the PPS, then the PPS will communicate to the SDM through a non class 2 communications circuit that a PPS fault is present. The SDM will then set DTC B0092 indicating a problem within the PPS.