Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 945 (IMMOBILIZER SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC CODE INDEX
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Diagnostic Code Index
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Diagnostic Code Index
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| DTC B2947 | Security System Sensor Power Circuit Low |
| DTC B2948 | Security System Sensor Power Circuit High |
| DTC B2957 | Security System Sensor Data Circuit Low |
| DTC B2958 | Security System Sensor Data Circuit High |
| DTC B2960 | Security System Sensor Data Incorrect But Valid |
| DTC B3031 | Security System Controller In Learn Mode |
| DTC B3033 | Security System Indicates Tamper |
| DTC P1626 | Theft Deterrent Fuel Enable Signal Lost |
| DTC P1631 | Theft Deterrent Fuel Enable Signal Not Correct |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.