Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 939 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Removal Procedure
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the hood.
- Remove the air cleaner assembly from the vehicle.
- For the 4.3L engine, refer to Air Cleaner Assembly Replacement .
- For the 4.8L, 5.3L, and 6.0L engine, refer to Air Cleaner Assembly Replacement .
- Disconnect the electrical connector from the cruise control module.
- Disconnect the cruise control cable from the cruise control module. Refer Cruise Control Cable Replacement .
- Remove the nuts (2) that retain the cruise control module to the cruise control bracket.
- Remove the cruise control module (3) from the cruise control bracket (1).
- Remove the cruise control module (3) from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.