Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 939 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cruise Control Module, Cruise Control Bracket & Nuts

Courtesy of GENERAL MOTORS CORP.

Install the cruise control module (3) to the vehicle.
Install the cruise control module (3) to the cruise control bracket (1).

NOTE: Refer to Fastener Notice .

Install the nuts (2) that retain the cruise control module (3) to the cruise control bracket (1).
Tighten: Tighten the nuts to 5 N.m (44 lb in).
Connect the cruise control cable to the cruise control module. Refer to Cruise Control Cable Replacement .
Connect the electrical connector to the cruise control module.
Install the air cleaner assembly to the vehicle.
- For the 4.3L engine, refer to Air Cleaner Assembly Replacement .
- For the 4.8L, 5.3L, or 6.0L engine, refer to Air Cleaner Assembly Replacement .
Close the hood.
Refer to Control Module References for programming and setup information.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.