SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 927 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 4.3L - INTRODUCTION (2 OF 2))SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Fastener Tightening Specifications

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 GMC Savana and 2007 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications

Application Specification
Metric English
Accelerator Control Cable Bracket Fasteners 12 N.m 106 lb in
Accelerator Pedal Assembly Mounting Bolts 5 N.m 44 lb in
AIR Hose Assembly Mounting Bolts 25 N.m 18 lb ft
AIR Hose Assembly Retainer Bolts 40 N.m 30 lb ft
AIR Hose Retainer Clip Locknut 10 N.m 89 lb in
AIR Pump Assembly Hold-Down Block Bolt 25 N.m 18 lb ft
AIR Pump Assembly Mounting Bolts 25 N.m 18 lb ft
AIR Solenoid Mounting Bracket Fastener 4 N.m 35 lb in
Air Cleaner Assembly Bolts 18 N.m 13 lb ft
Air Cleaner Outlet Duct Nut 2 N.m 18 lb in
Air Cleaner Outlet Resonator Adapter Stud 8 N.m 71 lb in
Air Shield Mounting Bolts 33 N.m 24 lb ft
Camshaft Position Sensor Screws 2.2 N.m 20 lb in
Crankshaft Position Sensor Mounting Bolt 8 N.m 71 lb in
Distributor Cap Screws 2.4 N.m 21 lb in
Distributor Mounting Clamp Bolt 25 N.m 18 lb ft
Distributor Rotor Retaining Screws 2 N.m 18 lb in
Distributor Rotor to Reluctor Wheel Screws 19.5 N.m 14 lb ft
EGR Pipe to Exhaust Manifold 25 N.m 18 lb ft
EGR Pipe to Intake Manifold 10 N.m 89 lb in
EGR Retaining Fastener to Pipe Bracket 25 N.m 18 lb ft
EGR Valve Attaching Bolts 25 N.m 18 lb ft
Engine Coolant Temperature (ECT) Sensor 20 N.m 15 lb ft
Evaporative Emission (EVAP) Canister Bracket Bolt 12 N.m 106 lb in
Exhaust Gas Recirculation (EGR) Pipe to Exhaust Manifold Fittings 30 N.m 22 lb ft
Fuel and EVAP Pipe Retainer Nut 28 N.m 21 lb ft
Fuel Fill Hose Clamp 2.75 N.m 24 lb in
Fuel Injector Retainer Locknuts 3 N.m 27 lb in
Fuel Pipe Attaching Nuts 27 N.m 20 lb ft
Fuel Pipe Bracket Retaining Bolt 6 N.m 53 lb in
Fuel Pipe Fittings 27 N.m 20 lb ft
Fuel Pipe Retainer Clip Nut 28 N.m 21 lb ft
Fuel Pipe Retainer Nuts 3 N.m 27 lb in
Fuel Pipe Retaining Clips Bolts 12 N.m 106 lb in
Fuel Tank Strap Attaching Bolts 20.5 N.m 15 lb ft
Heated Oxygen Sensor (HO2S) 42 N.m 31 lb ft
Idle Air Control (IAC) Valve Attaching Fastener 3 N.m 27 lb in
Ignition Coil Mounting Screws 11 N.m 97 lb in
Ignition Control Module (ICM) Mounting Screws 3.5 N.m 31 lb in
Knock Sensor (KS) Bolt 25 N.m 18 lb ft
Mass Air Flow (MAF) Sensor Clamps 4 N.m 35 lb in
Powertrain Control Module (PCM) Connector End Fasteners 8 N.m 71 lb in
Purge Valve Mounting Nuts 12 N.m 106 lb in
Spark Plugs - New Aluminum Heads 20 N.m 15 lb ft
Spark Plugs - New Iron Heads 30 N.m 22 lb ft
Spark Plugs - Used Heads 15 N.m 11 lb ft
Steering Linkage Shield Mounting Bolts 33 N.m 24 lb ft
Throttle Body Assembly Retaining Studs 9 N.m 80 lb in
Throttle Position (TP) Sensor Fasteners 2 N.m 18 lb in
Upper Manifold Bolts 8 N.m 71 lb in
Upper Manifold Nuts 8 N.m 71 lb in
Vacuum Module Attaching Bolts 8 N.m 71 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.