SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 927 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 4.3L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSACCELERATOR CONTROL CABLE REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page is about a different car, the 2007 GMC Savana and 2007 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover. Refer to Engine Cover Replacement .
  2. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
    3. Fig 1: Identifying Accelerator Cable/Throttle Body Lever
    GM325556Courtesy of GENERAL MOTORS CORP.
  3. Remove the accelerator cable from the throttle lever.
    4. Fig 2: Expanded View Of Accelerator Cable From The Engine Cable Bracket
    GM325557Courtesy of GENERAL MOTORS CORP.
  4. Remove the accelerator cable from the engine cable bracket.
    5. Fig 3: View Of Accelerator Cable At Accelerator Pedal
    GM26784Courtesy of GENERAL MOTORS CORP.
  5. Remove the accelerator cable from the accelerator pedal (2).
    6. Fig 4: View Of Accelerator Cable At Bulkhead
    GM26786Courtesy of GENERAL MOTORS CORP.
  6. Remove the accelerator cable from the bulkhead (1).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.