SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 925 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESABS INDICATOR INOPERATIVETEST DESCRIPTION
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Test Description

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Test Description
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step tests if the IPC is able to illuminate the ABS indicator during the bulb check.
ABS Indicator Inoperative

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the ABS indicator.
Does the ABS indicator illuminate?		 Go to Diagnostic Aids Go to Step 3 
3 Replace the instrument panel cluster (IPC). Refer to Instrument Cluster Replacement .
Did you complete the replacement?		 Go to Step 4  -
4
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the ABS indicator.
Does the ABS indicator illuminate?		 System OK Go to Step 3 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.