Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting Electrical Connector From Door Lock Receiver
    GM871215Courtesy of GENERAL MOTORS CORP.
  1. Perform the following to install the door lock receiver (1) to the door lock receiver bracket.

    Slide the tab on door lock receiver (1) into the door lock receiver bracket and snap into place to secure.

  2. Connect the electrical connector (1) to the door lock receiver (2).
  3. Install the I/P trim panel. Refer to Instrument Panel Upper Trim Pad Replacement .
  4. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.