Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  3. Fig 1: View Of Horn Plunger At Steering Column
    GM399638Courtesy of GENERAL MOTORS CORP.
  4. Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.
  5. Fig 2: Horn Contact Plate Retaining Screws
    GM395771Courtesy of GENERAL MOTORS CORP.
  6. Remove the horn contact plate retaining screws from the steering wheel.
  7. Remove the horn plunger from the steering wheel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.